IPB

Welcome Guest ( Log In | Register )

 
 
Reply to this topicStart new topic
> relay board cover screw, 1973 1.7 The screw for the relay board cover just spins.
elsargento
post Feb 17 2019, 03:26 PM
Post #1


Newbie
*

Group: Members
Posts: 25
Joined: September 9, 2006
From: Topanga, California
Member No.: 6,802



Any ideas before I chop it out and butcher the cover ? Fuel pump inop trying to get to the relay to troubleshoot.
Go to the top of the page
 
+Quote Post
Dr. 914
post Feb 18 2019, 09:22 AM
Post #2


Dr. 914
****

Group: Admin
Posts: 3,449
Joined: April 12, 2010
From: Marietta, Georgia
Member No.: 20,846



the cover easily comes off after removing the nut, just move it sideways as you pull it up. Check the two middle black round relays and the rear fuse, (should be blue 25 amp)


QUOTE (elsargento @ Feb 17 2019, 04:26 PM) *
Any ideas before I chop it out and butcher the cover ? Fuel pump inop trying to get to the relay to troubleshoot.
Go to the top of the page
 
+Quote Post
elsargento
post Feb 18 2019, 01:27 PM
Post #3


Newbie
*

Group: Members
Posts: 25
Joined: September 9, 2006
From: Topanga, California
Member No.: 6,802



QUOTE
the cover easily comes off after removing the nut, just move it sideways as you pull it up. Check the two middle black round relays and the rear fuse, (should be blue 25 amp)


QUOTE
Any ideas before I chop it out and butcher the cover ? Fuel pump inop trying to get to the relay to troubleshoot.


thanks Dr. but the problem is the knurl nut wont turn and the whole screw turns with the nut. Dremel time going to cut pedals like a flower around the nut then maybe it will pull through the flower so to speak.
Go to the top of the page
 
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 

RSS Lo-Fi Version Time is now: September 19, 2019 - 06:03 AM