IPB

Welcome Guest ( Log In | Register )

 
 
Reply to this topicStart new topic
> Rocker Arm Assembly Shaft Position
SpitBrick
post May 12 2017, 01:34 PM
Post #1


Newbie
*

Group: Members
Posts: 3
Joined: May 10, 2017
Member No.: 30,548



I've just got my heads back from someone who was refurbishing them. And as part of it I had to resemble them.

I'm at the point where I'm trying to figure out how to put it together for when I hook it up to the cylinders and I have a question about the placement of the rocker arms shafts.

The difference between each end is in a lip. And I was wondering if there was supposed to be a preference for either the lip side being against the head, or against the washer and nut?

(IMG:http://i.imgur.com/ZPT67kA.jpg)

(IMG:http://i.imgur.com/HCpPPmw.jpg)

Go to the top of the page
 
+Quote Post
Dr. 914
post May 12 2017, 02:03 PM
Post #2


Dr. 914
****

Group: Admin
Posts: 3,231
Joined: April 12, 2010
From: Marietta, Georgia
Member No.: 20,846



good question, anyone have the answer why it would go down?
Go to the top of the page
 
+Quote Post
indianmort
post Jun 1 2017, 12:28 PM
Post #3


indianmort
**

Group: Members
Posts: 234
Joined: April 14, 2010
From: sugarloaf ny
Member No.: 20,862



so the adjuster sits on valve stem and cup receives the ball end of the pushrod.
Go to the top of the page
 
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 

RSS Lo-Fi Version Time is now: November 23, 2017 - 12:37 PM